Cutting And Placing Thermal Pads - EK Quantum Vector2 RE RTX 3080 ABP Set D-RGB User Manual

Gpu water block with active backplate

Hide thumbs Also See for Quantum Vector2 RE RTX 3080 ABP Set D-RGB:

Table of Contents

CUTTING AND PLACING THERMAL PADS

Thermal Pad F – 1.0 mm (120 x 16 mm)

120 mm

1 mm

STEP 1

Thermal Pad - 120 x 16 x 1.0 mm

STEP 2

STEP 1

CAUTION: You must remove the protective foil from both

sides of the thermal pad before installation.

Replacement thermal pads:

Thermal Pad F 1.0mm – (120 x 16mm) EAN: 3830046996732

Your EK-Quantum Vector

comes with thermal pads that have to be cut into smaller pieces to

cover all the VRM components. EK made sure to provide you with

more than an adequate quantity of thermal pads to complete this step.

For this step, you will need:

Scissors

STEP 2

The cardboard is printed in scale 1:1. Cut the thermal pads

according to the size specifications printed on the PCB cardboard.

Once cut to size, thermal pads should be placed on the GPU PCB,

as shown in the image.Be careful to choose the right thermal pad

thickness. Thermal pads of three different thickness levels (1 mm,

1.5 mm, 2 mm) are included.

- 11 -

RE RTX 3080/90 ABP Set D-RGB block

Table of Contents

Do you have a question about the Quantum Vector2 RE RTX 3080 ABP Set D-RGB and is the answer not in the manual?

Quantum vector2 re rtx 3090 abp set d-rgb