Installing The Active Backplate - EK Quantum Vector2 RE RTX 3080 ABP Set D-RGB User Manual

Gpu water block with active backplate

Hide thumbs Also See for Quantum Vector2 RE RTX 3080 ABP Set D-RGB:

Table of Contents

INSTALLING THE ACTIVE BACKPLATE

Thermal Pad F – 1.0 mm (120 x 16 mm)

120 mm

Thermal Pad F – 1.5 mm (120 x 16 mm)

120 mm

Thermal Pad F – 2.0 mm (120 x 16 mm)

120 mm

STEP 1

1 mm

Replacement thermal pads:

Thermal Pad F 1.0mm – (120 x 16mm) EAN: 3830046996732

Thermal Pad F 1.5mm – (120 x 16mm) EAN: 3830046996749

Thermal Pad F 2.0mm – (120 x 16mm) EAN: 3830046996756

After attaching the GPU PCB, few more thermal pads need to be

placed on the back side of the GPU PCB. Once cut to size, thermal

pads should be placed on the GPU PCB, as shown on image

1.5 mm

below (STEP 2). EK made sure to provide you with more than an

adequate quantity of thermal pads to complete this Step.

For this step, you will need:

2 mm

STEP 1

- 14 -

CAUTION: You must remove the protective foil from both

sides of the thermal pad before installation.

Scissors

Table of Contents

Do you have a question about the Quantum Vector2 RE RTX 3080 ABP Set D-RGB and is the answer not in the manual?

Quantum vector2 re rtx 3090 abp set d-rgb