Quick Reference Table - Supermicro SuperServer SYS-E102-9AP-LN4-E User Manual

Quick Reference Table

Jumper Description
JPME2 Manufacturing Mode
JPME2 Power Force On
JSIM_OPT1 SIM Card Detection
LED Description
LED1 Power Good LED
LED2 M.2 Active LED (for JMD1)
LED3 M.2 Active LED (for JMD2)
LED4 M.2 Active LED (for JMD3)
LED5 M.2 Active LED (for JMD4)
LED6 GbE LAN Active LED (for JLAN1)
LED7 GbE LAN Active LED (for JLAN2)
LED8 GbE LAN Active LED (for JLAN3)
LED9 GbE LAN Active LED (for JLAN4)
Connector
BT1
COM1
FAN1
I-SATA0
J2
J5
JD1
JF1
JGP1
JHDMI1
JLAN1 - JLAN4
JMD1
JMD2, JMD3
JMD4
JMD2_SRW1
Note: Table continues on the next page.
Description
Battery Connector
(To clear the CMOS, remove the battery and power input, short pins 1-2 for more than 10
seconds and install the battery.)
Serial COM Port (supports RS-232 x 1)
System Fan Header
Intel PCH SATA 3.0 Port
USB 2.0 Header
SO-DIMM Slot (bottom side layout)
Speaker Header (Pins 1-4)
Front Control Panel Header
8-bit General Purpose I/O Header
Back Panel HDMI Port
LAN1 - LAN4 (RJ45) Ports
M.2 B-Key 2242/3042 Slot (supports USB2.0/3.0 with Nano SIM for LTE/3G)
(supports SATA upon request)
M.2 B-Key 2242/3042 Slots (supports USB2.0/3.0 with Nano SIM for LTE/3G)
M.2 E-Key 2230 Slot (supports PCIe x1/USB2.0 with WiFi + BT)
M.2 Mounting Screw for JMD2 (bottom side layout)
14
Chapter 1: Introduction
Default Setting
Pins 3-5: Normal
Pins 2-4: Power Force On
Pins 1-2 (JSIM1)
Pins 3-4 (JSIM2) Closed: Low Active
Pins 5-6 (JSIM3)
Status
Solid Green: All Power Good
Solid Red: Power Fail
Activity Behavior: Depends on Module
Activity Behavior: Depends on Module
Activity Behavior: Depends on Module
Activity Behavior: Depends on Module
Blinking Amber: LAN Active
Blinking Amber: LAN Active
Blinking Amber: LAN Active
Blinking Amber: LAN Active