Control Panel - Supermicro SuperServer SYS-E102-9AP-LN4-E User Manual

Control Panel

Power switches and status LEDs are located on the control panel on the front of the chassis.
LAN4 LED
Feature Description
Power Button Applies or removes power from the power supply to the server; standby power is maintained
Indicates power is being supplied to the system power supply; illuminated when the system is
Power LED
operating normally
HDD LED Indicates hard drive activity when flashing
LTE1 LED
WAN connection
LTE2 LED
WAN connection
LTE3 LED
WAN connection
WIFI LED Wireless Network connection
LAN1 LED Indicates network activity on LAN port 1 when flashing
LAN2 LED Indicates network activity on LAN port 2 when flashing
LAN3 LED Indicates network activity on LAN port 3 when flashing
LAN4 LED Indicates network activity on LAN port 4 when flashing
Status
Continuous on and red
Blinking red (1Hz)
Blinking red (0.25Hz)
Solid blue
Blinking blue
HDD LED
LAN3 LED
LAN2 LED
LAN1 LED
LTE1 LED
LTE2 LED
LTE3 LED
WIFI LED
Figure 1-2. Control Panel
Control Panel Features
Status LED
Description
An overheat condition has occurred.
(This may be caused by cable congestion.)
Fan failure, check for an inoperative fan.
Power failure, check for a non-operational power supply.
UID has been activated locally to locate the server in a
rack environment.
UID has been activated using IPMI to locate the server in
a rack environment.
10
Chapter 1: Introduction
Power LED
Power Button