Table of Contents
Advertisement
Quick Links
MODEL S
SUBMERSIBLE
SOLIDS HANDLING PUMP
INSTALLATION AND SERVICE MANUAL
For use with product built with Marathon
motor.
®
NOTE! To the installer: Please make sure you provide this manual to the owner of the equip ment or to the responsible
party who maintains the system.
Item # E-03-304 | Part # 5625-304-1 | © 2012 Pentair Pump Group, Inc. | 10/19/12
Advertisement
Table of Contents
Related Manuals for Pentair HYDROMATIC S
Summary of Contents for Pentair HYDROMATIC S
- Page 1 NOTE! To the installer: Please make sure you provide this manual to the owner of the equip ment or to the responsible party who maintains the system. Item # E-03-304 | Part # 5625-304-1 | © 2012 Pentair Pump Group, Inc. | 10/19/12...
-
Page 2: General Information
CALIFORNIA PROPOSITION green wire for ground. Be sure General 65 WARNING: green wire is connected to a good ground such as water pipe or Information This product and ground stake. related accessories contain chemicals known to the State of Thank you for purchasing your California to cause cancer, birth Heat Sensors: Hydromatic... - Page 3 Pumps al ter nate operation on each Alarm Controls: heat sensors are not properly successive cycle. connected the warranty is void. The alarm level is usually set Two pumps operate together only above the override level so the if sump level rises to the third alarm will signal only if the Hydromatic electrical equipment or over ride control.
-
Page 4: Installation Instructions
only with short dis charge lines, collect for the pump to han dle. A General oth er wise water will re turn to the frequent pumping cycle is rec om- sump and cause short cycling of mend ed for best op er a tion. Information the pump. -
Page 5: Pump Operation
to operate until level drops to without caus ing trouble. For Pump turn-off point. excessive amp draw on one leg, the power company should Operation 5. Allow sump level to rise to be consulted. start other pump. Notice run lights on panel; pumps should Starting Systems: alternate on each suc ces sive Pump... - Page 6 bottom of stator housing and 8. Check top bearing. If clean Pump remove plug in top of hous ing and does not turn rough, to allow air to enter. bearings can be reused and it Maintenance is not necessary to com plete ly 3.
-
Page 7: Pump Troubleshooting
on hardwood block. This will sub mers ible oil. Fill chamber 2. Selector switch may be in the push the bearing from the until covers Off position. hous ing and will force upper windings. Leave air space 3. Control circuit trans form er seal from shaft. - Page 8 out of water without burning Pump up the winding, but the heat sensors give motor Troubleshooting prolonged life by controlling winding temperature. Pump does not deliver prop er 3. Pump may be op er at ing on capacity. a short cycle due to sump being too small or from water 1.
-
Page 9: Parts List
Parts List ® For use with product built with Marathon motor. Ref. Part Part Ref. Part Part Ref. Part Part Description Qty. Description Qty. Description Qty. 21929A002 Eye Bolt 00296-013-2 Impeller 5-3/4” Dia. 24407C213 Stator 1 HP 230/460/3/60, 152740355 35’ Cord Cap Assembly 14-4 00296-014-2 Impeller 5-5/8”... - Page 10 44 23 24 25 26...
-
Page 12: Standard Limited Warranty
Pentair Hydromatic will cover only the lower seal and labor thereof for all dual seal pumps. Under no circumstance will Pentair Hydromatic be responsible for the cost of field labor, travel expenses, rented equipment, removal/reinstallation costs or freight expenses to and from the factory or an authorized Pentair Hydromatic service facility.