Pentair Hydromatic SW33 Series Installation And Service Manual
Pentair Hydromatic SW33 Series Installation And Service Manual

Pentair Hydromatic SW33 Series Installation And Service Manual

Submersible sump/ effluent pumps

Advertisement

Quick Links

PumP InstallatIon and
servIce manual
SW/SD/VS33 & 50
Submersible Sump/
Effluent Pumps
SD33
SW33
VS33
SW50
VS50
SD50
NOTE! TO ThE iNSTallEr: Please make sure
you provide this manual to the owner of the
pumping equipment or to the responsible party
who maintains the system.
293 WriGhT STreeT, Delavan, Wi 53115 WWW.hyDrOmaTic.cOm
Ph: 888-957-8677
269 Trillium Drive, KiTchener, OnTariO, canaDa n2G 4W5
Ph: 519-896-2163
W-03-445 (rev. 03/04/13)
© 2013 Pentair, ltd. all rights reserved.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Hydromatic SW33 Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Pentair Hydromatic SW33 Series

  • Page 1 293 WriGhT STreeT, Delavan, Wi 53115 WWW.hyDrOmaTic.cOm Ph: 888-957-8677 269 Trillium Drive, KiTchener, OnTariO, canaDa n2G 4W5 Ph: 519-896-2163 W-03-445 (rev. 03/04/13) © 2013 Pentair, ltd. all rights reserved.
  • Page 2: General Information

    Approx. Turn-On Level General 2. risk of Electrical Shock: SW33A ” Information Connect only to a properly SD33A ” ground ed receptacle. VS33A ” Approx. Turn-Off Level Thank you for purchasing your Septic tank is to be vented SW33A ” Hydromatic pump.
  • Page 3: Performance Curve

    7. Connect to power source using 3-prong grounded 115 volt receptacle. remove ground pin from elec tri cal plug. Do not use an ex ten sion cord. 8. For proper automatic operation make sure the pump power cord is plugged into the back of the piggyback re cep tacle on the switch cord.
  • Page 4: Pump Troubleshooting

    to a start position, replace the electrical components of the Pump com plete piggyback switch pump. Starting with the power as sem bly and retest with cord, inspect for cuts or nicks Servicing new assembly. in the insulation. If the cord is damaged, it must be replaced! 5.
  • Page 5 4. If pump is using the series cord Check vent hole in pump case 1. Inlet in pump base may be plug, the two plugs may not be for plugging. clogged. Remove pump and plugged tight together. clean out open ings. 2.
  • Page 6 SW/SD/VS33 & 50 Parts List...
  • Page 7: Parts List

    SW/SD/VS33 & 50 Parts List Ref. No. Description Part No. Qty. Ref. No. Description Part No. Qty. PLUG – PIPE 14981-001-1 STATOR (1/2 HP) 14591-001-1 HANDLE – PUMP 8522-006-1 SCREW – HEX #8-32 x 3” 145-009-1 SCREW – QUADREX #10-24 x 3/8” 14770-006-1 ROTOR (1/3 HP) 14590-010-1...
  • Page 8: Limited Warranty

    Limited Warranty HYDROMATIC warrants to the original consumer purchaser (“Purchaser” or “You”) of HYDROMATIC Sump Pumps, Effluent Pumps, Sewage Pumps (other than 2-1/2”), and Package Systems, that they will be free from defects in material and workmanship for the Warranty Period of 36 months from date of manufacture. Our warranty will not apply to any product that, in our sole judgement, has been subject to negligence, misapplication, improper installation, or improper maintenance.

This manual is also suitable for:

Hydromatic sd33 seriesHydromatic vs33 seriesHydromatic sw50 seriesHydromatic sd50 seriesHydromatic vs50 seriesHydromatic sw33a ... Show all

Table of Contents