Download Print this page

Pentair Hydromatic HE Series Installation And Service Manual

High head filtered effluent pumps

Advertisement

Quick Links

293 WriGhT STreeT, Delavan, Wi 53115 WWW.hyDrOmaTic.cOm
Ph: 888-957-8677
269 Trillium Drive, KiTchener, OnTariO, canaDa n2G 4W5
Ph: 519-896-2163
© 2013 Pentair, ltd. all rights reserved.
NOTE! TO THE iNSTallEr: Please make sure
you provide this manual to the owner of the
pumping equipment or to the responsible party
who maintains the system.
InstallatIon and servIce Manual
High Head Filtered
HE Series
Effluent Pumps
W-03-405 (rev. 02/20/13)

Advertisement

loading

Summary of Contents for Pentair Hydromatic HE Series

  • Page 1 293 WriGhT STreeT, Delavan, Wi 53115 WWW.hyDrOmaTic.cOm Ph: 888-957-8677 269 Trillium Drive, KiTchener, OnTariO, canaDa n2G 4W5 Ph: 519-896-2163 W-03-405 (rev. 02/20/13) © 2013 Pentair, ltd. all rights reserved.
  • Page 2: General Information

    2. risk of Electrical Shock: directly from the entrance box. General There must be an ap pro pri ate- Connect only to a properly ly sized fuse or circuit breaker Information ground ed receptacle. in this line. Tying into existing Septic tank to be vented circuits may cause circuit in ac cor dance with local...
  • Page 3 6. A clamp, a weld, or both if 15.Do pump gasoline, • Running the pump with the necessary, is secured to the chem i cals, corrosives, dis charge completely closed. equipment grounding lead, the flammable liquids; they could • Pumping chemicals equip ment grounding terminal, ignite, explode, or damage corrosive liquids.
  • Page 4: Electrical Preparation

    3. Model Number Designation Se lec tion of proper size cable Pump Selection is very important. Undersized HE20-51 cable results in too low a and Inspection voltage supply to the motor Flow rate: 8 = 8 gpm and ultimate motor failure. 12 = 12 gpm 20 = 20 gpm Oversized cable will cost...
  • Page 5 4. Splicing Power Cables to 5. Motor grounding in struc tions: nOTE: n.E.C. requires that Pump: sub mers ible pumps be grounded at installation. After making sure your power WArning: reduced risk of cables are the proper AWG electric shock during operation size and specified length, of this pump requires the WArning: Failure to ground...
  • Page 6: Pump Troubleshooting

    reduced capacity Any or all the above Pump 1. Strainer or impellers partially 1. All known causes are checked Troubleshooting clogged or plugged. but system won’t work properly. • Pull pump and clean. • Call your Hydromatic dealer or your serviceman. The vast majority of service calls on these systems are caused by problems that are elec tri cal in For your reference...
  • Page 7 Pump Notes ______________________________________________ ______________________________________________ ______________________________________________ ______________________________________________ ______________________________________________ ______________________________________________ ______________________________________________ ______________________________________________ ______________________________________________ ______________________________________________ ______________________________________________ ______________________________________________ ______________________________________________ ______________________________________________ ______________________________________________ ______________________________________________ ______________________________________________ ______________________________________________ ______________________________________________ ______________________________________________ ______________________________________________ ______________________________________________ ______________________________________________ ______________________________________________...
  • Page 8: Limited Warranty

    Limited Warranty HYDROMATIC warrants to the original consumer purchaser (“Purchaser” or “You”) of HYDROMATIC Sump Pumps, Effluent Pumps, Sewage Pumps (other than 2-1/2”), and Package Systems, that they will be free from defects in material and workmanship for the Warranty Period of 36 months from date of manufacture. Our warranty will not apply to any product that, in our sole judgement, has been subject to negligence, misapplication, improper installation, or improper maintenance.