Table of Contents
Advertisement
Quick Links
MODELS FBHRSS,
FBHRSG, FGHRDS,
FBHRDG, HRS, HRD,
FBSSG, FBSDG, SS & SD
GRINDER PUMP
BASIN SYSTEMS
INSTALLATION AND SERVICE MANUAL
NOTE! To the installer: Please make sure you provide this manual to the owner of the equip ment or to the responsible
party who maintains the system.
Item # E-03-088 | Part # 5625-088-1 | © 2012 Pentair Pump Group, Inc. | 10/24/12
Advertisement
Table of Contents
Related Manuals for Pentair Hydromatic FBHRSS
Summary of Contents for Pentair Hydromatic FBHRSS
- Page 1 NOTE! To the installer: Please make sure you provide this manual to the owner of the equip ment or to the responsible party who maintains the system. Item # E-03-088 | Part # 5625-088-1 | © 2012 Pentair Pump Group, Inc. | 10/24/12...
-
Page 2: General Information
1 FBHRSS and 750) diameter sumps. General grinder systems use the Hydr-O- Simplex Hydr-O-Rail System Grind submersible grinder pump, Information mounted in a steel basin. which has cutter blades that grind 2 FBHRSG solids and send the slurry directly Simplex Hydr-O-Rail System Thank you for purchasing your into the inlet of the centrifugal mounted in a fiberglass basin. - Page 3 water with a PH ranging from 6 to Codes located at the bottom of the 9, specific gravities from 0.9 to 1.1, pump by hand to be sure shaft All local wiring codes must viscosities ranging from 28 to 35 turns freely with slight drag.
- Page 4 Installing Simplex and Duplex tank. Guide ears on check about 3” of play in cords. IMPORTANT: Sealing blocks Hydr-O-Rail Component valve hold valve and flange Systems (Models HRS, HRD) place. Clearance (8) are shipped with three sealing flange is adjusted for (Simplex) and four (Duplex) Referring fig.
- Page 5 6. Measure from shoulder on Simplex units. If system is for 3/8” expansion anchors. base plate (32) (or shoulder on Duplex, assemble top center Fasten brace to basin with 3/8” intermediate rail guides if rail guide (39) and top center cap screws.
-
Page 6: System Operation
for expansion anchors. Secure insert check valve and piping This system can be ordered with cap screws. If basin is assembly through hole in without vent, if not required installed outdoors below pump cover (3). by local codes. frost level, a manway will be 9. -
Page 7: Pump Troubleshooting
Adjustment in the Hydr-O- any trapped air. If pump is For Duplex System, one pump Matic Grinder Pump Service piped in permanently, it will be should start when level reaches Manual. necessary to disconnect union first upper control and will at pump discharge to clear air. - Page 8 2. Cutters clogged. 2. If this is a new installation and Green run light stays on Amperage higher than the original start-up, the floats may 1. Selector switch may be in the nameplate will indicate this. be miswired into the control HAND position.
-
Page 9: System Parts List
System Fig. 1 Parts List Simplex Hydro-O-Rail System Model: FBHRSS or FBHRSG Simplex Duplex Hydr-O-Rail Systems (Models FBHRSS, FBHRSG, FBHRDS, and FBHRDG). See Fig. 1 or 2. 1. Basin assembly consisting of the following items: basin (30) (fiberglass or steel), basin cover (27), complete rail assembly (31) (32), gate valve extension (33) (if required), intermediate rail braces (if required), gate valve and sealing... - Page 10 Fig. 2 System Duplex Parts List Hydro-O-Rail System Model: FBHRDS or FBHRDG Part Description Simplex Qty. Duplex Qty. Part Description Simplex Qty. Duplex Qty. Discharge pipe assembly 5/16” Flat washer (1-1/2 and 2 hp) (from pump through check valve) 3/8” Flat washer (3 and 5 hp) Chain with shackle on each end 3/8”...
- Page 11 System Fig. 3 Parts List Simplex Hydro-O-Rail System Model: HRS Simplex Duplex Hydr-O-Rail Component System (Models HRS and HRD). See Fig. 3 or 4. 1. Basin cover (27), (50). 2. Control panel (28). 3. Pedestal (29) with mounting hardware identical to that on Page 6. 4.
- Page 12 Fig. 4 System Duplex Parts List Hydro-O-Rail System Model: HRD Part Description Simplex Qty. Duplex Qty. Part Description Simplex Qty. Duplex Qty. Intermediate side rail brace and top 4 Float hanger strap side rail brace Junction box assembly Intermediate center rail brace –...
- Page 13 System Fig. 5 Parts List Simplex Suspended System Model: FBSSG or SS Simplex and Duplex Suspended System (Models FBSSG and FBSDG). See Fig. 5 or 6. 1. Basin assembly consisting of the following items: basin (1), basin cover (2), pump cover (3) and support pipe assembly (4). 2.
- Page 14 THIS PAGE INTENTIONALLY LEFT BLANK...
- Page 15 THIS PAGE INTENTIONALLY LEFT BLANK...
- Page 16 Pentair Hydromatic will cover only the lower seal and labor thereof for all dual seal pumps. Under no circumstance will Pentair Hydromatic be responsible for the cost of field labor, travel expenses, rented equipment, removal/reinstallation costs or freight expenses to and from the factory or an authorized Pentair Hydromatic service facility.