DT SWISS L2 User Manual page 13

4.4 INSTALLING THE CABLE ON THE L3 REMOTE LEVER
1. Take the user manual of the component that is to be operated by the remote lever and check it for
information on how to mount the cable.
2. Screw in the cable adjuster (1) fully and then turn
it back out two turns.
→ This achieves the greatest adjustment
range.
3. Put a ferrule on the end of the cable
housing and insert the cable housing
into the cable adjuster (1) of the
remote lever.
4. Use a 2.5 mm hex key to unscrew the clamping screw (2) for the cable on the remote lever by a few
turns.
5. Push the cable through the cable adjuster (1) and push the cable end through the remote lever.
6. Pull the cable tight and screw in the clamping screw (2) to clamp the cable.
7. Adjust the cable adjuster (1) until there is sufficient cable tension to remove play at the remote
lever.
8. Trim off the protruding end of the cable and fit a cable end crimp on the cable.
L2 / L3 Remote Lever
1
2
13