Assembly - DT SWISS L2 User Manual

4. ASSEMBLY

4.1 INSTALLING THE L2 REMOTE LEVER
NOTE: The L2 remote lever is compatible with the
Matchmaker X interface. This allows the remote lever to
be attached directly to the clamp of a Sram brake lever
without a clamp.
1. Dismount the grip from the handlebar, open the
screw of the clamp slightly and slide the clamp onto
the left side of the handlebar.
2. Position the remote lever in such a way that the
lever can be comfortably reached with the thumb
and neither impairs its own function nor interferes
with the function of other control elements.
3. Tighten the fixing screw with a Torx T25 key with a
torque of max. 1.5 Nm.
→ If the remote lever is fitted on carbon handlebars, the maximum torque may be lower.
Observe the handlebar manufacturer's user manual!
4.2 INSTALLING THE CABLE AND CABLE HOUSING ON THE L2 REMOTE LEVER
1. Move the remote lever to the starting position (see picture).
2. Attach the cable housing and the cable adjuster.
→ Only cable housings with an outer diameter of 4.2 mm
must be used.
→ Before and after the cable adjuster there must be
at least one short piece of cable housing.
→ Screw in the cable adjuster completely and
then loosen one turn.
3. Shorten the cable housing to the desired
length.
4. Put the shift cable through the
remote lever.
5. Attach the cable to the component to be operated
and shorten it if necessary.
For more information, refer to the user manual
or the technical manual of the corresponding
component.
6. Check the function and readjust the cable if
necessary.
7. Repeat the above steps as necessary to assemble
a second cable.
L2 / L3 Remote Lever
11