Using Other General-Purpose Controllers - Roland Fantom-06 Reference Manual

Playing the General-Purpose Controllers

Using Other General-Purpose Controllers

In addition to the sliders and control knobs, the pitch bend/
modulation lever, pedal switches and expression pedals connected
to the PEDAL jacks, WHEEL 1–2, and the [S1]/[S2] buttons can
be used as general-purpose controllers. You can assign various
functions or parameters to these controllers.
* The functions operated by the pitch bend/modulation lever and
the HOLD jack are fixed.
1 .
Use the [ZONE 1-8/9-16] button to select the
zones that you want to work with (ZONE 1–ZONE
8 or ZONE 9–ZONE 16).
2 .
Select the current zone.
If necessary, make layer settings as well.
3 .
Operate a general-purpose controller.
The sound changes according to the assigned function.
Button Explanation
Varies the pitch. Other functions cannot be
Pitch bend lever
assigned.
Generates control change message CC#1.
Use the "System Control Source" system
parameter to set the control target
Modulation lever
(p. 170).
Other functions cannot be assigned.
Connect pedal switches or expression
pedals to these jacks to use them. Various
functions can be assigned.
PEDAL jack
(CTRL 1, CTRL 2)
Operate a pedal to use the assigned
function.
Connect a pedal switch to this jack to use
PEDAL jack
it. This can be used as a damper pedal.
(HOLD)
Other functions cannot be assigned.
Various parameters and functions can be
WHEEL1
assigned. To use the assigned function,
WHEEL2
move the wheel while you play.
Various parameters and functions can be
assigned.
[S1] button
[S2] button
To use the assigned function, press the
button.
MEMO
¹ Operating these general-purpose controllers affects the
zone(s) that are heard when you play the keyboard. (If you're
using layered settings, multiple zones are affected. If you're
not using layered settings, the current zone is affected.)
¹ The functions assigned to these general-purpose controllers
can be specified for the entire system or individually for each
scene. A system setting determines whether the system-wide
settings or the individual scene settings are used.
48 48
Parameter Explanation
Specifies whether the functions controlled
by a pedal connected to the PEDAL CTRL 1,
Pedal Assign Source 2 jacks are specified by the system settings
(SYS) or by the settings of the scene
(SCENE).
Specifies whether the functions controlled
by the wheels are specified by the system
Wheel Assign Source
settings (SYS) or by the settings of the
scene (SCENE).
Specifies whether the functions controlled
by the [S1], and [S2] buttons are specified
S1-S2 Assign Source
by the system settings (SYS) or by the
settings of the scene (SCENE).
* Because the functions of the pitch bend/modulation lever and
the PEDAL HOLD jack are fixed, there is no setting screen for their
assignments.
For details on the setting screens and their operation, refer
to "System Parameter" (p. 164).
MEMO
By holding down the [SHIFT] button and operating the WHEEL
1–2, [S1]–[S2] button, or a pedal connected to the PEDAL CTRL 1,
2 jack you can access the setting screen for assigning a parameter
or function. For details, refer to "Parameter Guide" (PDF) or "System
Parameter" (p. 164).