Table of Contents
Advertisement
4. Handling Procedure
Traveling
Traveling backward
Braking position
Traveling
Braking position
Traveling forward
Set the forklift in transfer form.
Raise the fork to a height of 10 to 15 cm from the floor.
When a cargo is loaded, tilt the mast backward to stabilize the cargo.
Traveling forward (toward the handle)
(1)
Turn the handle to the traveling position.
If the handle position is low or high, the brake is activated so that
position
the forklift does not run.
(2)
If the traveling knob attached to the steering handle is turned to the
front (toward the operator's position), the forklift travels forward.
Turning the traveling knob widely increases the traveling speed.
Once the traveling knob is released, it will return to the neutral position.
The traveling knob is attached to both sides of the steering handle.
Traveling form
Move the forklift by pulling the vehicle body,
instead of pushing it.
To move the forklift backward when inserting
the fork into a pallet, etc., run the forklift at a
low speed that enables the operator to slowly
and securely handle it.
27
Advertisement
Table of Contents
