Table of Contents
Advertisement
B: InitTimbre
Refer to "3. SYNTH Parameters."
C: Init ch Lvl
This function initializes the output level for each filter of the
carrier.
When the levels are initialized, the output level value will be
127.
Procedure
1 Press the SELECT [16] key, and then press the CUR-
SOR [®] key twice.
The LCD screen will show Page 20C: UTILITY "Init ch
Lvl."
20C UTILITY
Init ch Lvl
2 Press the [+/YES] key.
You will be asked to confirm the initialize operation.
20C UTILITY
Are You Sure OK?
3 Press the [+/YES] key once again.
The output levels will be initialized, and the display will
indicate "Completed."
4 Press the [EXIT] key.
You will return to the first screen of the "Init ch Lvl"
function.
D: Init ch Pan
This function initializes the panpot for each filter of the car-
rier.
When this is done, the panpot of each filter will be at CNT
(center output).
Procedure
1 Press the SELECT [16] key, and then press the CUR-
SOR [®] key three times.
The LCD screen will show Page 20D: UTILITY "Init ch
Pan."
20D UTILITY
Init ch Pan
2 Press the [+/YES] key.
You will be asked to confirm the initialize operation.
20D UTILITY
Are You Sure OK?
3 Press the [+/YES] key once again.
The output levels will be initialized, and the display will
indicate "Completed."
4 Press the [EXIT] key.
You will return to the first screen of the "Init ch Pan"
function.
52
OK?
OK?
Advertisement
Table of Contents
