Set The Volume Of Each Oscillator; Make Filter Settings - Korg MS2000R Owner's Manual

Korg owner's manual analog modeling synthesizer ms2000, ms2000r
Hide thumbs Also See for MS2000R:
Table of Contents

Advertisement

e. Adjust the pitch of oscillator 2 in semitone units
Rotate the [SEMITONE] knob.
The LCD screen will show Page 06C: OSC 2 "Semitone."
The most common way to use this is to set oscillator 2
one or two octaves lower than the pitch of oscillator 1.
06C OSC 2
Semitone:
f. Adjust the pitch of oscillator 2
Rotate the [TUNE] knob.
The LCD screen will show Page 06D: OSC 2 "Tune."
By slightly skewing the pitch to create a detuning effect,
you can give the sound more depth.
06D OSC 2
Tune:

3. Set the volume of each oscillator

a
b
a. Adjust the volume of oscillator 1
Rotate the MIXER [OSC1] knob.
The LCD screen will show Page 07A: MIXER "OSC 1
Level."
07A MIXER
OSC 1 Level: 127
b. Adjust the volume of oscillator 2
Rotate the MIXER [OSC2] knob.
The LCD screen will show Page 07B: MIXER "OSC 2
Level."
07B MIXER
OSC 2 Level: 100
4. Make filter settings
-12
a. Select the filter type
+06
b. Adjust the brightness of the sound
c. Adding character to the sound
d. Adjusting the depth of the effect from EG1
EG1 changes the filter cutoff over time. "EG 1 Int" adjusts
the depth of this effect.
b
a
Press the [FILTER TYPE] key.
Each time you press the key, the filter type will change,
and the LED of the selected filter type will light.
The filter type will have a major impact on the character
of the sound.
Rotate the FILTER [CUTOFF] knob.
The LCD screen will show Page 08B: FILTER "Cutoff."
Rotating the knob toward the right (increasing the
value) will brighten the sound.
08B FILTER
Cutoff:
Rotate the FILTER [RESONANCE] knob.
The LCD screen will show Page 08C: FILTER "Reso-
nance."
Rotating the knob toward the right (increasing the
value) will dramatically change the character of the
sound.
The resonance effect will also be significantly affected by
the filter type and cutoff settings.
08C FILTER
Resonance:
Rotate the FILTER [EG 1 INT] knob.
The LCD screen will show Page 08D: FILTER "EG 1 Int."
Rotating the knob to the right of center (+ values) will
cause the effect to be applied to the cutoff in the positive
(+) direction.
Rotating the knob to the left of center (– values) will
cause the effect to be applied to the cutoff in the negative
(–) direction.
08D FILTER
EG 1 Int:
Basic Guide
c
d
060
045
+40
21

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ms2000

Table of Contents