Specify Time-Varying Change In The Tone; Adjust The Output Of The Timbre - Korg MS2000R Owner's Manual

Korg owner's manual analog modeling synthesizer ms2000, ms2000r
Hide thumbs Also See for MS2000R:
Table of Contents

Advertisement

5. Specify time-varying change in the tone

Use EG 1 to create time-varying change in the cutoff fre-
quency (FILTER "Cutoff").
If you wish to use the front panel knobs to adjust the
EG 1 parameters, use the SEQ EDIT [SELECT] key to
make the SEQ 1–3 LED's go off.
Note on
a
a: Attack Time
b: Decay Time
a
a. Adjust the speed at which the tone will change dur-
ing the attack
Rotate the EG 1 [ATTACK] knob.
The LCD screen will show Page 10A: EG 1 "Attack."
Rotating the knob toward the right will cause the tone to
change more slowly, and rotating it toward the left will
cause the tone to change instantly.
10A EG 1
Attack:
If rotating the knob does not produce an effect, try
adjusting the FILTER [EG 1 INT] knob, or make sure
that the SEQ EDIT SEQ 1–3 LED's are dark. If these
LED's are lit, it is not possible to edit the EG or LFO.
The knobs will function to edit the sequence data.
b. Adjust the speed at which the tone will change dur-
ing the decay
Rotate the EG 1 [DECAY] knob.
The LCD screen will show Page 10B: EG 1 "Decay."
Rotating the knob toward the right (increasing the
value) will cause a longer decay time until the sustain
level is reached.
10B EG 1
Decay:
c. Adjust the brightness of the sustained sound
Rotate the EG 1 [SUSTAIN] knob.
The LCD screen will show Page 10C: EG 1 "Sustain."
The change in brightness produced by the [SUSTAIN]
knob will depend on the setting of the [EG 1 INT] knob.
10C EG 1
Sustain:
22
Note off
c
b
d
c: Sustain Level
d: Release Time
b
c
d
000
030
060
d. Adjust the speed at which the tone will change after
the note is released
Rotate the EG 1 [RELEASE] knob.
The LCD screen will show Page 10D: EG 1 "Release."
Rotating the knob toward the right will make the sound
change more slowly, and rotating it toward the left will
make it change instantly.
Release:

6. Adjust the output of the timbre

Time
a
b
c
d
a. Adjust the volume of the timbre
Rotate the [LEVEL] knob.
The LCD screen will show Page 09A: AMP "Level."
If the volume changes over time, this level will be the
maximum level that occurs during the change in vol-
ume.
Level:
b. Adjust the output panpot (stereo position)
Rotate the [PAN] knob.
The LCD screen will show Page 09B: AMP "Panpot."
When the knob is in the center (CNT), the output will be
centered.
Panpot:
c. Select the envelope source for the volume
Press the [EG 2 /GATE] key.
Each time you press the key, the envelope source will
change.
If you want the volume change over time, select EG 2
([EG 2/GATE] key LED dark).
If you want the volume to sound at a fixed level, as on
an organ, select GATE ([EG 2/GATE] key LED lit).
10D EG1
000
09A AMP
127
09B AMP
CNT

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ms2000

Table of Contents