Tuner; Rhythm; Setup: Specify The Tempo And Rhythm - Korg D1200 Owner's Manual

TUNER

Here you can use the built-in tuner to tune an instrument
connected to the [INPUT 1/GUITAR IN] jack.
You cannot select this page while recording or playing.
Nor can you record while in this page.
So that the pitch can be detected accurately, effects will
automatically be turned off while this page is displayed.
1
3
1. CENT Scale ...................................... (–50...+50)
When the tuning is correct, the "
the 0 position in the middle of the meter, and the "
flat indicator and " " sharp indicator will both light. If
the pitch is flat, only the "
the pitch is sharp, only the "
light.
The pitch deviation is displayed in units of cents. (100
cents is one semitone, and 1200 cents is one octave.)
2. NoteDisplay............................................. (C...B)
Indicates the name of the note that is closest to the input
pitch.
It is not possible to detect two or more pitches simulta-
neously.
3. Calib .................................. [435...440...445Hz]
Adjusts the calibration frequency.
Normally you will leave this set to "440."
2
" symbol will be at
"
" flat indicator will light. If
" sharp indicator will

RHYTHM

Here you can make settings for the tempo, time signature,
and rhythm (metronome) of the song.
If the counter is displaying "MBT" (measure, beat, 1/96th
beat), the counter will operate according to the specified
tempo.
Tempo/rhythm settings can also be made in the
[SONG] "SelSong" tab page ( p.116).

SetUp: Specify the tempo and rhythm

1
4
1. TempoSource.....................................................
[Manual, TempoMap, TempoTrack]
Specifies the tempo source.
Press the " " button and make your selection in the dia-
log box that appears.
Manual: The current "Tempo" and "Beat" settings will
be used. It will not be possible to automatically change
the tempo, time signature, and rhythm pattern during
the song.
TempoMap: The tempo, time signature, and rhythm
pattern will change automatically during the song,
according to the tempo maps you create. Use the "Tmp-
Map" tab page to create tempo maps.
TempoTrack: The tempo will be determined by the
recorded tap tempo or MIDI clock. Use the "TmpTrack"
tab page to record tap tempo or sequencer tempo, and
then select "TempoTrack" here.
The time signature will follow the settings you created
in the "TmpMap" tab page.
"TempoTrack" can be selected after the data is created.
2. Tempo........................................[40...240, (***)]
Specifies the tempo when "TempoSource" is set to
"Manual."
If "TempoSource" is set to "TempoMap," this area will
indicate the tempo for the current time location as speci-
fied by the tempo maps you created in the "TmpMap"
tab page. If "TempoSource" is set to "TempoTrack," this
area will indicate "***."
The range is =40–240.
3. Beat....................................... [(01/04...16/16)]
Specifies the time signature when "TempoSource" is set
to "Manual."
If "TempoSource" is set to "TempoMap" or "Tem-
poTrack," this area will indicate the time signature for
Reference
7
3
6
5 2
95