Korg D1200 Owner's Manual page 108

1. Exec.(Execute) ...................................................
Executes the check drive function.
1a. Area.......................... [Unused, Full, CurSng]
Specifies the area that will be checked.
Unused: Of the unused area, check and repair the first 2
GB that will be used next.
Full: Check and repair the entire area.
CurSong: Check and repair the area used by the cur-
rently selected song.
Press the [YES/OK] button to begin the drive check.
The Check Drive operation requires a certain
amount of time.
If "Area" is "Full": approximately 4 hours 30 min-
utes
If "Area" is "Unused": approximately 25 minutes
If "DiskBusy" appears even after you perform the
Check Drive operation, you will need to optimize
the track data ( p.59, 111: [TRACK] "EditTrk" tab
page "Optimize Track").
In a studio or similar location, vibration due to ultra-
low frequencies may cause "DiskBusy" to occur. If
this is the cause of the error message, you can solve
the problem by moving the D1200 to a different lo-
cation, rather than executing the Check Drive oper-
ation.
"EraseCD-RW": Erase a CD-RW disc
This operation erases all data that has been written to a CD-
RW disc. When you erase a disc, you will once again be able
to use the entire disc area as a blank disc.
When you execute "Erase CD-RW," all data on that disc
will be lost.
You cannot execute "Erase CD-RW" on a disc other than
a CD-RW.
106
1. Exec.(Execute) ...................................................
Executes erasure of the CD-RW disc.
1
1a. Quick SW ......................................[On, Off]
Selects the erasure method for the CD-RW.
On: A high-speed erase will be performed on the
1a
entire CD-RW disc. Since only the track information will
be erased, the erasure will require less time. This will
not affect writing.
Off: The entire CD-RW disc will be erased com-
pletely. Use this setting if the disc is not recognized even
after it was erased with the "Quick" turned on.
Press the [YES/OK] key to begin the erasure.
"Format/S": Format the song drive
This operation formats the song drive of the internal hard
disk.
1. Exec.(Execute) ...................................................
Executes formatting of the song drive.
1a. Quick SW ......................................[On, Off]
Selects the format type.
On: Select this if you want to erase the song data
in a single operation. Since this will initialize only the
management area, it will not require much time.
Off: Select this if the "DiskError" message
appears frequently.
A substantial amount of time will be required if you
execute the format operation with "Quick" turned
"Off." Song drive (38 GB): approximately 10 hours
1
2a. Force .............................................[On, Off]
Execute formatting even if the drive contains protected
songs.
On: Forcibly execute formatting even if the drive
contains a song protected by "Protect Song."
Off: If a song protected by "Protect Song" exists
on the drive, the "Song Protect" message will appear
when you attempt to execute, and the operation will be
aborted.
Press the [YES/OK] key to begin the format operation.
1a
1
1a
2a