Mm14: Exciter – Limiter; Mm15: Exciter – Cho/Flng; Mm16: Exciter – Phaser; Mm17: Exciter – Mt.delay - Korg D12 Owner's Manual

68: MM14: Exciter – Limiter
[Excit2, Lmtr]
69: MM15: Exciter – Cho/Flng
[Excit2, ChFl1]
70: MM16: Exciter – Phaser
[Excit2, Phaser]
71: MM17: Exciter – Mt.Delay
[Excit2, Mt.Dly]
72: MM18: Limiter – P4EQ
[Lmtr, P4EQ]
73: MM19: Limiter – Cho/Flng
[Lmtr, ChFl2]
74: MM20: Limiter – Phaser
[Lmtr, Phaser]
75: MM21: Limiter – Mt.Delay
[Lmtr, Mt.Dly]
76: MM22: OD/HiG – Cho/Flng
[ODHiG, ChFl1]
77: MM23: OD/HiG – Phaser
[ODHiG, Phaser]
78: MM24: OD/HiG – Mt.Delay
[ODHiG, Mt.Dly]
79: MM25: OD/HiG – AmpSim
[ODHiG, AmpSim]
80: MM26: Wah – AmpSim
[Wah, AmpSim]
81: MM27: Decimator – AmpSim
[Decim, AmpSim]
82: MM28: Decimator – Comp
[Decim, Comp1]
83: MM29: Cho/Flng – Mt.Delay
[ChFl2, Mt.Dly]
84: MM30: Phaser – Cho/Flng
[Phaser, ChFl2]
85: MM31: AmpSim – Tremolo
[AmpSim, Trml]
86: MM32: Reverb – Gate
[Reverb, Gate]
87: MM33: MicSim – Limiter
[MicSim, Lmtr]
124
Effects within multi-effect programs
MM1–MM33, and their parameters
Here are explanations of the parameters of each effect in the
multi-effect chains listed above.
P4EQ
(Parametric 4band EQ)
Fc1 (Band1 Cutoff [Hz])........ 20Hz...1.0kHz Sets the center frequency of Band 1
Q1 (Q)........................................... 0.5...10.0 Sets the bandwidth of Band 1
G1 (Gain [dB]) ..........................–18...+18dB Sets the gain of Band 1
Fc2 (Band2 Cutoff [Hz])........ 50Hz...5.0kHz Sets the center frequency of Band 2
Q2 (Q)........................................... 0.5...10.0 Sets the bandwidth of Band 2
G2 (Gain [dB]) ..........................–18...+18dB Sets the gain of Band 2
Fc3 (Band3 Cutoff [Hz]).... 300Hz...10.0kHz Sets the center frequency of Band 3
Q3 (Q)........................................... 0.5...10.0 Sets the bandwidth of Band 3
G3 (Gain [dB]) ..........................–18...+18dB Sets the gain of Band 3
Fc4 (Band4 Cutoff [Hz]).... 500Hz...20.0kHz Sets the center frequency of Band 4
Q4 (Q)........................................... 0.5...10.0 Sets the bandwidth of Band 4
Gain4 (Gain [dB])......................–18...+18dB Sets the gain of Band 4
Trim (Trim)......................................... 0...100 Sets the parametric EQ input level
Excit1
(Exciter1)
Blend (Exciter Blend)................–100...+100 Sets the intensity (depth) of the Exciter
Empha (Emphatic Point)................... 0...140 Sets the frequency range to be empha-
Excit2
(Exciter2)
This adds Pre LEQ and Pre HEQ to Exciter 1.
Blend (Exciter Blend)................–100...+100 Sets the intensity (depth) of the Exciter
Empha (Emphatic Point)................... 0...140 Sets the frequency range to be empha-
Trim (EQ Trim)................................... 0...100 Sets the EQ input level
LEQG (Pre LEQ Gain [dB]) ......–15...+15dB Sets the gain of Low EQ
HEQG (Pre HEQ Gain [dB]) .....–15...+15dB Sets the gain of High EQ
Wah
(Wah/Auto Wah)
FcBtm (Frequency Bottom)............... 0...100 Sets the lower limit of the wah center
FcTop (Frequency Top) ..................... 0...100 Sets the upper limit of the wah center
*Mode (Sweep Mode) ........Auto, Pedal, LFO Selects the control from auto-wah,
*Speed (LFO Frequency [Hz])..0.02...20.0Hz Sets the LFO speed
Reso (Resonance)............................ 0...100 Sets the resonance amount
LPF (LPF) .........................................Off, On Switches the wah low pass filter on and
:Mode
Select "Pedal" if you wish to use an expression pedal to control the
wah.
Comp1
(Compressor1)
Sense (Sensitivity)............................ 1...100 Sets the sensitivity
Attack (Attack) .................................. 1...100 Sets the attack level
Level (Output Level).......................... 0...100 Sets the output level of the compressor
effect
sized
effect
sized
frequency
frequency
modulation source, and LFO
off