H2I ONEOF Accuracy Motion User Manual page 25

6.4.1.1 Creation of parameters
FIG. 6-13 - Accuracy Motion (Creation of parameters)
• Create a new set of parameters by clicking Add Parameters (1).
• Set as default: "Default" means that when a new device is connected, the measurement will be
made with this parameter. If no default parameter is selected, the "built-in" parameter will be
used. You can choose a set of parameters to be used as default by clicking the option at the top
right of the screen (5).
• Criteria: possibility to link parameters to display criteria (4).
• Sequence: possibility to link parameters to a sequence (3).
• Data folder: Here you can define where to save your results (2).
Using the application 24|36