H2I ONEOF Accuracy Motion User Manual page 16

6.2.1 Control bar
The control bar allows you to select the standard measurement positions, to start or stop a
measurements sequence, to start or stop a single measurement according to the chosen
position, to save and to visualize the parameters related to the Accuracy Motion.
FIG. 6-3 - Accuracy Motion (Control bar)
(1) Measurement positions
(2) Measurement sequence control
(3) Simple measures control
6.2.1.1 Measurement positions
The standard available measurement positions are DU, DD, CD, CR, CU, CL.
[See Measuring positions, page 8]
6.2.1.2 Performing a measurement
Simple measures
The control bar (see FIG. 6-3) allows you to make a simple measurement by selecting a
position.
The Simple measures control (3) button enables you to stop or restart the measurement.
Selecting a new position allows the measurement to be continued at the newly selected
position.
Sequence measurement
The Measurement sequence control button (2) is used to start or stop a sequence of
measurements.
A measurement cannot be performed without parameters. When a device is connected, a
set of default parameter, defined in the parameters tab, will be used. If no default
parameters are set in the parameters tab, the application will use the "built-in"
parameters instead. . You can view these parameters by clicking on the Device
parameters button (6) located in the Control bar (voir FIG. 6-3).
To view the Device parameters, remember to select the Device overview window.
6.2.1.3 Saving a measurement
The Measurement saving button (4) of the Control bar (see FIG. 6-3) enables you to save the
measurement that has just been made.
(4) Measurement saving
(5) Exporting results
(6) Device parameters
Using the application 15|36