Chapter 1: Connection Of Equipment; Introduction - Kenwood DV-5050M Instruction Manual

Chapter 1: Connection of Equipment

1-1 Introduction

This manual describes the standard, most typical connections of the player. When an associated system component is connected, also refer to their instruction manuals.
For details on the connection of the following components, see the indicated reference pages.
Preparation of Standard Remote Control Unit ..................... @
Preparation of Keyboard Remote Control Unit .................... @
STANDBY mode ..................................................................... @
Connection of Video Outputs ............................................... #
Connection of Audio Output ................................................ %
Daisy Chain Connection ....................................................... *
PC Link Connection .............................................................. )
DVD Control Function .......................................................... )
Before Start
Do not install the player in a place where the remote
control sensor is subjected to direct sunlight or the light
of a fluorescent lamp base on high-frequency lighting
(inverter system, etc.). Otherwise, the control range of
the standard remote will be reduced.
Do not insert the power cord plugs of the player and the
connected components until all of the components have
been connected.
Be sure to insert all connection cables securely. If a cable
is plugged incompletely, lack of video, lack of audio or
noise may result.
Before connecting or disconnecting a connection cord,
be sure to unplug the power plug from the wall power
outlet. If a connection cable is connected or disconnected
while the power plug is left connected, malfunction or
equipment damage may result.
CAUTION
Be sure to adhere to the following, or proper ventilation will be blocked causing damage or fire hazard.
÷ Do not place any objects impairing heat radiation onto the top of the unit.
÷ Leave some space around the unit (from the largest outside dimension including projection) equal to or greater
than, shown below.
Top panel : 10 cm Side panel : 10 cm
Chapter 1: Connection of Equipment
Back panel : 10 cm
11