Inserting Discs; In Regard To All Data Read Mode - Kenwood DV-5050M Instruction Manual

3-4 Inserting discs

Up to 403 discs can be loaded in the stocker. Disc
exchange also is possible during playback.
The discs can be changed during playback without
stopping the currently played disc.
Be sure to operate a button when opening/closing
the disc door or rotating the stocker. Never
attempt to move the stocker with your hand.
Never let your hand or any object enter inside the
unit.
Operation procedure
1.
Press the OPEN/CLOSE button on the player main
unit to open the disc door. (Pressing the button again
closes the disc door.)
This unit cannot play back 8 cm discs. Do not
attempt to play an 8 cm disc for this may result
in malfunction.
÷ Place the disc to be played along the groove on the
slot.
÷ Do not insert more than one disc in a slot.
÷ When handling a disc, take care not to touch the
disc surface.
÷ Please do not use discs which are not round
because they may cause malfunction.
2.
Turn the DISC knob and bring the slot with the disc
to be placed to the front.
÷ If you are operating the remote, press the DISC
+(up), – (down) button.
3.
Insert the disc vertically.
÷ Insert it so that the side to be played back faces
leftward.
disc label side
Stocker
4.
Repeat 2 and 3 to insert discs.
5.
Press the OPEN/CLOSE button on the player to close
the disc door.
÷ When the disc door closes :
The unit starts detection of discs in the stocker
("DETECTION" is displayed during this).
Ejecting the disc
Operation procedure
1.
Turn the DISC knob on the main unit to select a disc.
Press the EJECT 0 button.
2.
When "REMOVE DXXX" is displayed :
A disc is inserted in the slot with the same disc number
as the disc being loaded. It is not permitted to insert
another disc in a slot from which the disc has been
loaded. Remove the inserted disc and insert it in an
idle slot.
Chapter 3: Basic Operation

3-5 In regard to ALL DATA READ mode

The disc information for all discs will be read. We
recommend to execute this mode before playback after
discs have been exchanged.
Close the disc door before operation.
Operation procedure (remote)
1.
Press the MODE button.
2.
Press the DISC +(up), – (down) button, then select
"ALL DATA READ".
3.
Press the SET button.
÷ To display the title on a LCD remote control unit
(provided with a KENWOOD Receiver or optional),
perform the all data read operation first, and
operate the LCD remote control unit with the disc
door closed. For the operation of the LCD remote
control unit, refer to the instruction manual
provided with your receiver or LCD remote control
unit.
÷ If you are operating the keyboard remote, press the
ALL DATA READ button.
÷ To quit ALL DATA READ mode, Press the 7 button.
(DV-5900M only)
29