AMT Datasouth Fastmark M10XPd/Gen-2 User Manual page 5

Thermal barcode printer

Hide thumbs

Table Of Contents

Table of Contents

3. DO NOT disassemble the battery.

4. DO NOT throw the battery in municipal waste.

5. The symbol of the crossed out wheeled bin indicates that the battery should not be placed in

municipal waste.

The printhead may be hot and could cause severe burns. Allow the printhead to cool.

CE Statement:

This equipment complies with EU radiation exposure limits set forth for an uncontrolled environment.

This equipment should be installed and operated with minimum distance 20 cm between the radiator &

your body.

All operational modes:

2.4GHz: 802.11b, 802.11g, 802.11n (HT20), 802.11n (HT40)

5GHz: 802.11a,

The frequency, mode and the maximum transmitted power in EU are listed below:

2400 MHz – 2483.5 MHz: 19.88 dBm (EIRP)

5150 MHz – 5250 MHz: 17.51 dBm (EIRP)

5150-5350MHz for Only indoor use

5470-5725MHz for indoor/outdoor use

Restrictions In AZE

National restrictions information is provided below

Frequency Band

5150-5350MHz

5470-5725MHz

Hereby, AMT Datasouth Corp. declares that the radio equipment type [Wi-Fi] IEEE 802.11 a/b/g/n is in

compliance with Directive 2014/53/EU

Country

No license needed if used indoor and

Azerbaijan

power not exceeding 30mW

- iv -

Remark

Table of Contents

Show Quick Links

Hide quick links:

Table of Contents

Need help?

Do you have a question about the Fastmark M10XPd/Gen-2 and is the answer not in the manual?

Questions and answers

PaulineBayer

March 10, 2025

Label is not printing correctly

1 comments:

Mr. Anderson

May 14, 2025

Incorrect label printing on the AMT Datasouth M10XPd/Gen-2 can be caused by:

1. Wrong label size setup – Ensure the correct label size is set.
2. Dirty printhead – Clean the printhead.
3. Dirty platen roller – Clean the platen roller.
4. Incorrect RS-232 setting – Re-set the RS-232 settings.
5. Incorrect sensor sensitivity – Calibrate using Auto Gap or Manual Gap.
6. Media guide not touching label edge – Adjust the media guide left or right.
7. Label or ribbon not loaded correctly – Reload them properly.
8. Using incompatible ribbon or media – Use correct types.
9. Incorrect print density – Adjust the density setting.
10. Ribbon or label roll is empty – Replace with new rolls.
11. Ribbon or label installed incorrectly – Reinstall properly.

This answer is automatically generated