Connector Board - HP TBD Maintenance And Service Manual

3. Remove the connector board cables (3).
Reverse this procedure to install the connector board cables.

Connector board

To remove the connector board, use this procedure and illustration.
Table 5-6 Connector board description and part number
Description
For use on computer models equipped with WWAN capability
For use on computer models equipped without WWAN capability
Before removing the connector board, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
4. Remove the power cable (see
5. Remove the connector board cables (see
Remove the connector board:
1. Release the ZIF connector (1) to which the SIM cable is connected, and then disconnect the SIM cable from
the connector board.
Preparation for disassembly on page
Battery on page 33).
SIM cable (select products only) on page
Connector board cables on page
31).
Battery on page 33).
37).
40).
Spare part number
N01957-001
N01956-001
Connector board 41