Table of Contents
Advertisement
Remove the WWAN module:
1.
Remove the Phillips M2.0 × 3.4 screw (1) that secures the WWAN module to the system board. (The WWAN
module tilts up.)
2.
Remove the WWAN module bracket (2).
The WWAN module bracket is included in the Bracket Kit, spare part number N01962-001.
3.
Disconnect the WWAN antenna cables (3) from the terminals on the WWAN module.
NOTE:
The #5 red WWAN antenna cable connects to the WWAN module #5 Main terminal. The #6 blue
WWAN antenna cable connects to the WWAN module #6 Aux terminal.
4.
Remove the WWAN module (4) by pulling the module away from the slot at an angle.
WWAN module
35
Advertisement
Table of Contents
