Wlan Module - HP TBD Maintenance And Service Manual

5. If the WWAN antenna is not connected to the terminal on the WWAN module, you must install a protective
sleeve on the antenna connector, as shown in the following illustration.
Reverse this procedure to install the WWAN module.

WLAN module

To remove the WLAN module, use this procedure and illustration.
Table 5-4 WLAN module descriptions and part numbers
Description
Intel Wi-Fi 6 AX201 ax 2×2 + Bluetooth 5.0 MU-MIMO M.2 2230 non-vPro 160 MHz MIPI+BRI WW with 2
antennas WLAN module
IMPORTANT:
authorized for use in the computer by the governmental agency that regulates wireless devices in your country
or region. If you replace the module and then receive a warning message, remove the module to restore device
functionality, and then contact technical support.
Before removing the WLAN module, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
Remove the WLAN module:
1. Remove the Phillips M2.0 × 3.4 screw (1) that secures the WLAN module to the system board. (The WLAN
module tilts up.)
2. Remove the WLAN module bracket (2).
The WLAN module bracket is included in the Bracket Kit, spare part number N01962-001.
36 Chapter 5 Removal and replacement procedures for authorized service provider parts
To prevent an unresponsive system, replace the wireless module only with a wireless module
Battery on page
Preparation for disassembly on page
33).
Battery on page
Spare part number
L92724-005
31).
33).