Sensor Board - HP TBD Maintenance And Service Manual

Remove the sensor board cable:
1. Release the ZIF connector (1) to which the sensor board cable is connected, and then disconnect the sensor
board cable from the connector board.
2. Release the ZIF connector (2) to which the sensor board cable is connected, and then disconnect the sensor
board cable from the sensor board.
3. Remove the sensor board cable (3).
Reverse this procedure to install the sensor board cable.

Sensor board

To remove the sensor board, use this procedure and illustration.
Table 5-5 Sensor board description and part number
Description
Sensor board
NOTE: The sensor board spare part kit does not include the sensor board cable. The sensor board cable is
included in the Cable Kit, spare part number N02955-001.
Before removing the sensor board, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
4. Remove the sensor board cable (see
Remove the sensor board:
1. Remove the Phillips M2.0 × 3.4 screw (1) that secures the sensor board to the computer.
Preparation for disassembly on page
Battery on page 33).
Sensor board cable on page
31).
Battery on page 33).
38).
Spare part number
N01958-001
Sensor board 39