Selecting The Video Signal Type - JVC CA-NXF3 Instructions Manual

Preparation (continued)
Selecting the video signal
type
To view an image on the TV screen, select the
video signal type correctly according to the TV
after connecting the main unit to the TV.
■ IMPORTANT
• Slide the remote control mode
selector to [SHIFT].
11
Do not connect the power cable until all other connections have been made.
Remote control
mode selector
2/3 (cursor)/
ENTER
1
Turn on the main unit.
• Refer to "Turning on/off the main unit" on
page 13.
2
Press [DVD 3] or [USB 3].
• When a disc is loaded or a USB device is
connected, press
7
3
Press [SCAN MODE].
• The current video signal type appears.
Example: When "PAL. 576I" is selected as
the video signal
4
Press 2 or 3 (cursor) to select the
video signal type suitable for the
TV.
• When the TV is connected to the [VIDEO]
terminal or the [COMPONENT] terminals,
the video signal type can be selected as
instructed below.
- Select "PAL. 576I" for a TV only compatible
with a PAL interlaced video signal.
- Select "PAL. 576P" for a TV equipped with
a component terminal and compatible with
a PAL progressive video signal.
- Select "NT. 480I" for a TV only compatible
with an NTSC interlaced video signal.
- Select "NT. 480P" for a TV equipped with a
component terminal and compatible with
an NTSC progressive video signal.
• When the TV is connected to the [HDMI MON-
ITOR OUT] terminal, the video signal type can
be selected as instructed below.
- Select "AUTO" for normal usage. (the ini-
tial setting)
- Select "PAL. 576P", "PAL. 720P",
"PAL.1080I", "PAL.1080P", "NT. 480P",
"NT. 720P", "NT.1080I" or "NT.1080P" as
needed. (The selectable settings differ
according to the resolution of the con-
nected TV.)
• You can also select the video signal type by
repeatedly pressing [SCAN MODE].
to stop playback.