1. BEFORE STARTING 2. UNPACKING 3. MAIN COMPONENTS 4. DIMENSIONS 5. TECHNICAL PARAMETERS 6. INSTALLATION 7. COMMISSIONING 8. MAINTENANCE 9. TROUBLESHOOTING 10. LIQUIDATION PROCEEDINGS 11. CONCLUSIONS 2VV. Creating innovative solutions for you and your business since 1995. ver.1 31-05-21...
European standards included in the relevant EC Declaration of Conformity. The current and full version of www.2vv.cz the EC Declaration of Conformity can be found at 2VV. Creating innovative solutions for you and your business since 1995. ver.1 31-05-21...
If the unit was shipped at below 0°C temperatures, let it rest for at least 2 hours, without turning it on, so that its inner tem- perature can match the surroundings. 2VV. Creating innovative solutions for you and your business since 1995. ver.1 31-05-21...
Duct connection - diverted air (ETA) Duct connection - exhaust air (EHA) Heat exchanger with by-pass Fans Regulation unit - connecting power and accessories Condensate drain Filters Electric heating 2VV. Creating innovative solutions for you and your business since 1995. ver.1 31-05-21...
2600 HRDF-070 Characteristics of electric pre-heater Type Power [kW] ΔT (°C) HRDF-030 HRDF-050 10,3 HRDF-070 Characteristics of electric post-heater Type Power [kW] ΔT (°C) HRDF-030 HRDF-050 HRDF-070 2VV. Creating innovative solutions for you and your business since 1995. ver.1 31-05-21...
On the external parts of the unit may occur when combined with low exterior temperatures. If condensation occurs outside the unit, increase the venti- lation in the surroundings of the unit. 2VV. Creating innovative solutions for you and your business since 1995. ver.1 31-05-21...
Page 9
1150 mm min. 150 mm min. 850 mm HRDF1-030 min. 450 mm min. 850 mm no possible HRDF1-050 no possible no possible no possible HRDF1-007 no possible no possible 2VV. Creating innovative solutions for you and your business since 1995. ver.1 31-05-21...
Page 10
● The safe distance between combustible materials and the exhaust is 500 mm. ● The safe distance for combustible materials in all direc- Weight of unit (kg) tions is 100 mm. Type With electric With electric Without heating pre-heating and preheating post-heater HRDF1-030 HRDF1-050 82,5 HRDF1-070 2VV. Creating innovative solutions for you and your business since 1995. ver.1 31-05-21...
Page 11
The unit can only be installed in a position where the con- densate drain is pointing downwards. 90° ATTENTION! • The support of the unit should be sufficiently strong, it must correspond to the unit’s weight! • Given its weight, lifting equipment will be required when installing the unit (e.g. a forklift) or at least two more people to hold it. 2VV. Creating innovative solutions for you and your business since 1995. ver.1 31-05-21...
Page 12
Nachheizeinrichtung / DX / CO Afterheater / Nachheizeinrichtung / DX / CO By-pass ap / By-pass Klappe By-pass ap / By-pass Klappe Preheater / Vorwärmer Preheater / Vorwärmer 2VV. Creating innovative solutions for you and your business since 1995. ver.1 31-05-21...
Page 13
2)Connection of the second condensate drain for the summer period (the drain is blinded by a blanking plug)- connected according to the conditions. min 100mm 2VV. Creating innovative solutions for you and your business since 1995. ver.1 31-05-21...
Page 14
The terminal strip for the power cable is located in the housing of the control device. ATTENTION! The minimum dimensions of the safety grounding conductor must conform with the applica- ble local regulations. TECHNICAL INFORMATION ● The parameters of the wiring can be found on the label located on housing of the control device. 2VV. Creating innovative solutions for you and your business since 1995. ver.1 31-05-21...
Page 15
Terminal block for power supply (L), connection of N and PE cables and output of auxiliary power supply (24V) The power supply (12V, 24V) Engine fuse Fuse for accessories Servo drive by-pass 2VV. Creating innovative solutions for you and your business since 1995. ver.1 31-05-21...
Page 16
Внутренний датчик Czujnik przestrzenny Sensore ambientale Prostorové čidlo teploty Spatial sensor 2VV. Creating innovative solutions for you and your business since 1995. Внутренний датчик Czujnik przestrzenny Sensore ambientale Prostorové čidlo teploty Spatial sensor Внутренний датчик Czujnik przestrzenny Sensore ambientale Prostorové...
Page 17
The accessories must be powered with their with • min. 0.5 mm . Maximum length 50 m. their own external supply. For details on the power supply, refer to the docu- • Not included! mentation of the given accessory. 24 V 2VV. Creating innovative solutions for you and your business since 1995. ver.1 31-05-21...
Page 18
For protocol details (Modbus-TCP, Modbus-RTU), contact 2VV. RJ45 connector - Ethernet, Modbus TCP, BACnet (+12V- 27, GND- 28, CANH- 29, CANL- 30) MODBUS RTU (A-25, B-26, 28 or 66-GND) 2VV. Creating innovative solutions for you and your business since 1995. ver.1 31-05-21...
To activate the unit (Stand by mode), it is necessary to turn the main switch on (position I). After activation, the display on the control panel lights up and data download will start. After complete download of these data, the unit is ready for operation. 2VV. Creating innovative solutions for you and your business since 1995. ver.1 31-05-21...
(side cover held by magnet ) • replace filters • replace filters b) replacing the filter from the bottom cover • open the designer cover 2VV. Creating innovative solutions for you and your business since 1995. ver.1 31-05-21...
Unit is not Overheated fan or defect on Determine the cause of the overheating (defective bear- working thermal contact of inlet fan ing, short-circuit...) or replace the engine 2VV. Creating innovative solutions for you and your business since 1995. ver.1 31-05-21...
Page 22
The temperature of the air flowing into the inlet branch of the protection working in order to meet the building is not within the Passive House specifications. Auto- Passive house specifi- matic process cations 2VV. Creating innovative solutions for you and your business since 1995. ver.1 31-05-21...
Page 23
T2L 5x20mm 250V Fuse motor and accessories: label next to the fuse or directly on the fuse. READ CAREFULLY! When the power supply is resumed after an outage, the unit returns to the status it was before the outage. The unit always remembers its operational status and settings. If you aren’t able to find or remove the cause of the malfunction, or if the repairs require an intervention on the device, contact an authorised service. 2VV. Creating innovative solutions for you and your business since 1995. ver.1 31-05-21...
It is recommended to have the unit disassembled in a specialised facility so that the recyclable materials may be reused. Take the unusable components to a legal disposal site. The materials must be disposed of in compliance with the applicable regulations. 2VV. Creating innovative solutions for you and your business since 1995. ver.1 31-05-21...
The producer shall not be liable for damages caused as a result of improper installation and operation contra- ry to the manual and the common practice of installation and operation of ventilation devices and regulations systems. 2VV. Creating innovative solutions for you and your business since 1995. ver.1 31-05-21...