Tds Switch; Cooling Lines; Ice Transport Tube; Potable Water Line - Follett Horizon Elite H D710ABT Series Installation Instructions Manual

5.5

TDS switch

§ Set the TDS switch on the elctrical box.
– HIGH: for extended service life
– LOW: for low-scale water
5.7

Ice transport tube

➋
§ Slide ice machine into docking assembly
ensuring that drain tube is fully seated on
barbed drain fitting
§ Insert ice transport tube into coupling and tighten
➋
nut firmly .
BIN • TOP-MOUNT
TDS
HIGH
CLEAN
LOW
➊
➊
.
5.6

Cooling Lines

§ Install ice machine cooling water lines to docking
assembly.
5.8
Water solenoid, shut-off valve, and
potable water line options
5.8.1
If water solenoid is already mounted to
evaporator:
1. Insert potable water line into shut-off valve.
5.8.2
If this is an undercounter installation:
1. Mount water solenoid atop evaporator
and locate the shut-off valve inside the
machine. Insert potable water line into
shut-off valve.
5.8.3
If water solenoid is not mounted and
machine will not be installed undercounter:
1. Mount water solenoid to inside rear (upper
right corner) of docking assembly using
one screw.
2. Insert potable water line into shut-off
valve - locate the shut-off valve outside the
machine.
3. Insert outgoing line from shut-off valve into
push-in connection of water solenoid.
Horizon 710/1010/1410
In
Out
11