Table of Contents
Advertisement
Chapter 3: Hardware Setup
3. For the other end of the carrier, align
the alignment feature of the processor
with the carrier latch, and then gently
bend over the carrier end to have the
3
latch secured on the processor.
Latch
4. Align
PIN1
of the processor with the
corner cutout of the heat sink (if there are
Cutout
4
two corner cutouts on one heat sink,
either will do).
5. With a little pressure, push the four
corners of the carrier down to engage
5
their
latching
features
with
the
corresponding corners of the heat sink.
You might hear a clicking sound when the
latch clicks into place.
6. Inspect the four corners to make sure
the latches are all engaged. If correctly
latched, the corners of the carrier should
6
be tightly attached to the heat sink, with
Unlatched
no gap in-between observed.
25
Advertisement
Table of Contents
