Workstation A System Board - HP ProLiant xw2x220c Blade Workstation Maintenance And Service Manual

Remove the mezzanine card.
5.
CAUTION:
connector when installing the mezzanine card. Do not apply pressure to the edges of the card.
To replace the component, reverse the removal procedure.

Workstation A system board

To remove the component:
Power down the workstation blade (on page 11).
1.
Remove the workstation blade (on page 11).
2.
Access the internal workstation components (on page 12).
3.
Remove the workstation A USB key, if installed.
4.
If installed, remove one of the following:
5.
Hard drive (on page 13)
o
Cache module battery (on page 22)
o
Remove all DIMMs ("DIMMs" on page 15).
6.
Remove any mezzanine cards
7.
Remove the heatsink ("Heatsink" on page 15).
8.
Remove the cache module battery cable, if installed.
9.
To prevent damage to the workstation blade, apply pressure over the mezzanine
("Mezzanine card" on page 24).
Removal and replacement procedures 25