Access The Internal Workstation Components - HP ProLiant xw2x220c Blade Workstation Maintenance And Service Manual

Remove the workstation blade.
3.
Place the workstation blade on a flat, level work surface.
4.
WARNING:
internal system components to cool before touching them.
CAUTION:
blade before beginning any installation procedure. Improper grounding can cause ESD.

Access the internal workstation components

To access internal workstation components, remove workstation B assembly from workstation A assembly.
WARNING:
internal system components to cool before touching them.
CAUTION:
blade before beginning any installation procedure. Improper grounding can cause ESD.
Remove workstation B assembly
For access component identification, see "Access components (on page 47)."
To remove the component:
Power down the workstation blade (on page 11).
1.
Remove the workstation blade (on page 11).
2.
Place the workstation blade on a flat, level work surface with the bezel facing away from you.
3.
Extend the workstation B serial label pull tab.
4.
CAUTION:
Failure to use the jackscrews to remove and install the workstation B assembly can cause the
system boards to fail.
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To prevent damage to electrical components, properly ground the workstation
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To prevent damage to electrical components, properly ground the workstation
The jackscrews control the unseating and seating of critical system connectors.
Removal and replacement procedures 12