Display Screen Errors; Lighting Does Not Work - Bosch BULLS ICONIC EVO TR 1 750 Operating Instructions Manual

Symptom Cause
There is an unusual
smell.
Fumes are emitted from
the battery.
Table 49: Error solution for battery
9.1.4

Display screen errors

Symptom Cause
No data are shown on the The battery charge level may be
display screen if you insufficient.
press the on-off button
(battery).
Is the power switched on?
Is the battery charged?
Is the connector fitted to the power
cable correctly?
A component may be connected
which the system is unable to
recognise.
The gear level is not The gear level is only shown if the
electronic shifter is used.
shown on the display
screen.
The settings menu The product is designed in such a way
cannot be opened while that the settings menu cannot be
you are pedalling. opened if the system detects that
someone is riding the ebike. This is not
a malfunction.
The lock function cannot It may be a firmware error.
be set up or switched off.
The connect account has ...
been deleted or
deactivated and the lock
function is still activated.
Table 50: On-board computer error solution
9.1.5

Lighting does not work

Symptom Cause
Front lamp or rear lamp The basic settings in the electric drive
does not go on, even system have probably been configured
when the switch is incorrectly.
pressed.
The light is defective.
Table 51: Lighting error solution
About these operating instructions
Remedy
1 Remove from the battery immediately.
2 Contact the fire service immediately.
3 Observe all the warnings in Section 2 Safety.
1 Remove from the battery immediately.
2 Contact the fire service immediately.
3 Observe all the warnings in Section 2 Safety.
Remedy
1 Charge the battery.
2 Switch on the power.
 Press the On-Off button (battery) to switch the power on.
If the battery is fitted to the ebike and is being charged, it cannot
be switched on.
 Interrupt charging.
1 Check whether the connector is fitted to the power cable
correctly.
2 If the connector is not fitted correctly, contact your specialist
dealer.
 Contact specialist dealer.
1 Check that the power cable connector has not been
disconnected.
2 If this is not the case, contact your specialist dealer.
Stop the ebike.
1
2 Change settings when stationary only.
 Contact specialist dealer.
 Contact specialist dealer.
Remedy
Take ebike out of service immediately. 2
1
Contact specialist dealer.
191