6.5.4
Adjusting the saddle
6.5.4.1 Straightening the saddle
Position saddle in direction of travel. In doing
so, align the tip of the saddle with the top tube.
Figure 70: Positioning the saddle in direction of travel
Positioning the saddle with eightpins
suspension seat post
Only applies to ebikes with this equipment
1 Position saddle in direction of travel. In doing
so, align the tip of the saddle with the top tube.
2 Use a torque wrench to tighten the seat post
axle with 8 Nm.
Figure 71: Tightening the seat post axle
6.5.4.2 Adjusting the saddle height
To adjust the saddle height safely, either:
Push the ebike near to a wall so that the rider
•
can lean on the wall to support themselves or
Ask another person to hold the ebike.
•
1 Use the seat height formula to roughly set the
saddle height:
Seat height (SH) = inner leg length (I) × 0.9
2 Climb onto the bicycle.
3 Place your heel on the pedal and extend your
leg, so that the pedal is at the lowest crank
rotation point. Your knee should now be fully
extended.
Figure 72: Heel method
4 Take a test ride.
Riders should sit straight on the saddle at an
optimal saddle height.
If hips move to the left and right as you pedal,
•
the saddle is too high.
If your knees are painful after a few miles, the
•
saddle is too low.
Position the seat post according to needs if
necessary. Adjust the seat height with the
quick release or seat clamp bolt.
Operation
80