Removal And Replacement Procedures For Customer Self-Repair Parts; Service Door - HP OMEN Maintenance And Service Manual

5 Removal and replacement procedures for
Customer Self-Repair parts
This chapter provides removal and replacement procedures for Customer Self-Repair parts.
NOTE: The Customer Self-Repair program is not available in all locations. Installing a part not supported by
the Customer Self-Repair program may void your warranty. Check your warranty to determine if Customer
Self-Repair is supported in your location.
Component replacement procedures
NOTE: Details about your computer, including model, serial number, product key, and length of warranty,
are on the service tag at the bottom of your computer. See
NOTE: HP continually improves and changes product parts. For complete and current information on
supported parts for your computer, go to http://partsurfer.hp.com, select your country or region, and then
follow the on-screen instructions.
There are two screws that must be removed, replaced, and/or loosened when servicing Customer Self-Repair
parts. Make special note of the screw sizes and locations during removal and replacement.

Service door

Description
Service door, memory access
Before removing the service door, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
3. Disconnect all external devices from the computer.
Remove the service door:
1. Release the two captive Phillips screws (1) securing the service door to the base enclosure.
Labels on page 15 for details.
Component replacement procedures
Spare part
number
908719-001
29