Simple-Swap Drive And Drive Cage Replacement (Bay 3) - Lenovo ThinkSystem ST50 V2 Maintenance Manual

Figure 45. Installing the drive bay 2 cage
After you finish
1. Install simple-swap drives if necessary, see
2. Complete the parts replacement, see

Simple-swap drive and drive cage replacement (bay 3)

Follow this procedure to remove and install a simple-swap drive or drive cage from and into bay 3.
Remove a simple-swap drive (bay 3)
Follow this procedure to remove a simple-swap drive from bay 3.
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
About this task
Attention:
• Read "Safety inspection checklist" on page iv
work safely.
• Turn off the server and peripheral devices, and disconnect the power cords and all external cables, see
"Power off the server" on page
ThinkSystem ST50 V2 Maintenance Manual
62
"Install a simple-swap drive (bay 1-2)" on page
"Complete the parts replacement" on page
and "Installation guidelines" on page 41
9.
53.
158.
to ensure that you