Lenovo ThinkSystem ST50 V2 Maintenance Manual page 66

2. Check the drive activity LED on the front panel to verify if the drives are operating correctly.
Table 28. Drive activity LED behavior
Status
Solid on
Off
3. Use the Lenovo XClarity Provisioning Manager Lite to configure the RAID if necessary. For more
information, see https://sysmgt.lenovofiles.com/help/topic/LXPML/RAID_setup.html
Remove the drive cage (bay 1-2)
Follow this procedure to remove the drive cage from bay 1 or bay 2.
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
About this task
Attention:
• Read "Safety inspection checklist" on page iv
work safely.
• Turn off the server and peripheral devices, and disconnect the power cords and all external cables, see
"Power off the server" on page
• If the server is in a rack, remove it from the rack. See
• Remove any locking device that secures the server, such as a Kensington lock or a padlock.
• Place the server on its side with the cover up.
Watch the procedure
A video of this procedure is available at YouTube:
AU3iY3F7lq3qfqr5caGbIu
Procedure
Step 1. Make preparation for this task.
a. Remove the server cover. See
Attention: The heat sinks and processor could be very hot. To avoid burning yourself, wait for
a few minutes after turning off the server before you remove the server cover.
b. Remove the simple-wasp drive from drive bay 1 or drive bay 2, see
drive (bay 1-2)" on page
Step 2. Remove the bay 2 drive cage.
ThinkSystem ST50 V2 Maintenance Manual
58
Color Description
White The drives are active.
None The drives are not active.
9.
.
"Remove the server cover" on page
50.
and "Installation guidelines" on page 41
"Remove the server from the rails" on page
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
to ensure that you
137.
143.
"Remove a simple-swap