G.T.Power C6D Pro Manual page 24

Safety Timer
ON 240min
Capacity CutOff
ON 10000mAh
Key Beep ON
Buzzer ON
Input Power Low
Cut-Off 10.0V
Load Factory Set
Enter
Product Version
1.0.0 C6DPro
charging after the fast charging is over to avoid battery
overheating.
If you turn on safety timer when charging, safety timer will
start timing too.If system fault or system can't identify battery
capacity already full, this safety time set can stop battery
being over charged.The safety time should not shorter than
the battery fully charged time.
Capacity cut-o program set the maximum charging
capacity. If safety timer stopped work or system can't detect
the peak voltage,this program will stop charging/discharging
automatically if you've set the maximum charging capacity.
Beep sound on/o ; Buzzer sound on/o .
The program set the lowest cut-o input voltage value is
10-20V. If the voltage lower than the set voltage level,
procedure will be forced to end to protect input power.
Resume to default setting
Product version inquiry
34