G.T.Power C6D Pro Manual page 15

8.3 NiMH /NiCd battery charge and discharge cycling mode
Set the sequence on the left and the number of cycle (1-5) on the right. You can use this
function to balance and refresh or cut o battery.To avoid battery temperature rising, there
will be a brief cooling process after each charge and discharge cycle. In this process, press
"Batt type /stop" to stop the program.
NiMH CYCLE
DCHG>CHG 3V
NiMH 0.7A 7.70V
DSC 000:04 00000
8.4 NiMH/NiCD Battery second charge
The charger has the new program which can charge the battery for second time. (The
battery which do not use for a long time or the old battery or the battery which can not
arrive the Max voltage after the rst charge). In this way, this mode can make the battery's
capacity to the standard value and can extend the battery's using time.
NiMH RE-PEAK
2.1A
NiMH 2.1A 8.74V
CHG 000:31 00018
8.5 NiMH/NiCD Battery FB-DIS
FB-DIS can only be operated when the battery is connected to the input interface under DC
mode, otherwise will report error. The FB-DIS mode is to transfer the capacity of the battery
to be discharged to the input battery through the charger to achieve the purpose of
DCHG： discharge， CHG： charge
Press Start/Enter for 3 seconds to start the program.
Set the charge current in the left, set the second charge times
in the right. Press "Start/Enter" for 3seconds to start the
1
program and the program will stop by press "Batt type/Stop".
(Charge current 0.1-12.0A, 1-3 times)
Press Start/Enter for 3 seconds to start the program.
25