G.T.Power C6D Pro Manual page 21

Warmer 68℃
012:00 80W
13.4 PWM IN introduction
PWMIn Ous
65.53ms/15.25 Hz
13.5 PWM OUT introduction
PWMOut AUT-1
10.0ms 138
Short press Start/Enter to start the program, through press
INC/DEC to set heating temperature, heating time, heating
power.
Heating temperature 30°-100°, heating time 1-120 minutes,
heating power 10-100W.
After nished, long press ENTER to test interface. If need
re-set parameters, short press STOP back to set interface.
This program can be used to test the pulse width value of
other equipment. Connect the servo tester to the 3pin
temperature sensor port can measure the pulse width and
frequency of PWM directly.
Connect the servo with 3pin temperature sensor port can test
the servo parameters.
AUT-1， AUT-2， AUT-3 indicate three di erent speed automatic
mode, MAN is manual mode, THR is three position mode(
including the maximum position, the middle position, the
minimum position). Then set PWM periodic value, normally
the value is 50HZ(20MS), PWM value （ Only need to set the
min. Value and the max. Value under auto mode.）
31