G.T.Power C6D Pro Manual page 11

7.1 Lithium battery balance charge mode
This is for balancing the voltages of Lithium batteries of the battery pack to be fully charged.
Inner system will monitor each cell's voltage and restraint each cell's current to ful ll
balance charging. You need to connect the battery to the charger's output plug as well as
the balance port when charging.
LiPo BALANCE
5.2A 11.1V(3S)
R: 3SER S: 3SER
CONFIRM(ENTER)
L3Bo 1.0A 12.16V
CHG 000:08 00002
4.15 4.15 4.15 V
0.00 0.00 0.00 V
7.2 Discharging Lithium battery
The aim of discharging is to check the battery remaining capacity or to check the heath
status of battery.To avoid deep discharging, you need to set a right rated discharging
voltage when discharging. Lithium battery voltage should not lower than its rated voltage in
case causing any fast loss of battery capacity. In normal case no need to discharging Lithium
battery. For your safety, charger's discharging current should not exceed the maximum
discharging current speci ed by the battery manufacturer, rated voltage should not lower
than the lowest discharging voltage speci ed by the battery manufacturer to avoid deep
discharging.
The second line left side to set charge current value, right
side to set the battery pack voltage value. After done, press
and hold Start/Enter for 3 seconds to start the program.
（charge current： 0.1～12.0A,cell voltage： 1～6cells）
This shows the number of cells you set and the processor
detected. 'R' shows the number of cells found by the charger
and 'S' shows the number of cells you selected at previous
menu.If both numbers are the same, you can start charging
by press Start/Enter button.If not, press Batt type/Stop key go
back to the last menu to double check battery pack cell
number and charge again.
It shows the current charging status, press Batt type/Stop key
to stop charging.
It shows the individual cell voltage of each battery pack.
21