QMS 2060 WX Print User Manual page 110

Single In-Line
Memory Modules
(SIMMs)
2 Loosen the two screws, one on each end of the metal
mounting bracket cover on the rear of the printer.
3 Remove the controller board.
Using both hands, grab the two screws (on the metal mounting
bracket cover), slide the controller board out of the printer, and
set-it aside on a flat surface.
4 Position the controller board on a flat surface, so the control-
ler board lies flat and the bracket is facing you.
5 If necessary, remove an existing SIMM.
a Release the SIMM.
Pull the latches on each side of the SIMM connector outward
using both thumbs.
4-14 QMS 2060 WX Print System User ' s Guide