QMS 2060 WX Print User Manual page 109

Sie den Drucker aus und ziehen Sie den Netzstecker heraus bevor
Sie die Druckerabdeckung öffnen.
s Caution: This hardware change automatically restores defaults.
It's very important to protect the controller board from electrostatic
damage while performing this task.
If an anti-static wrist strap is provided in your printer option kit,
attach one end of it to your wrist and the other end to any convenient
electrical ground (for example, the bare metal chassis of equipment,
as on the back of a computer, that is plugged in but turned off).
Never attach the wrist strap to any piece of equipment with an
electrical current present. Turn off all power switches first. Plastic,
rubber, wood, painted metal surfaces, and telephones are not
acceptable grounding points. The printer isn't an acceptable
grounding point either because it must be unplugged before you
perform this task.
If you don't have an anti-static wrist strap, discharge your body's
static electric charge by touching a grounded surface before you
handle any printer boards or components and before removing the
controller board cover. Redischarge your body each time after
walking around and before touching the controller board again.
Handle the controller board carefully, and try to handle it by the edges
only.
Required Tool: Phillips screwdriver.
1 Turn off the printer, and then disconnect the power cord and
interface cable(s) from the printer.
Printer Options
Single In-Line
Memory Modules
(SIMMs)
4-13