Supermicro SuperWorkstation 5038A-I User Manual page 62

S W
uper orkstation 5038A-I User's Manual
Port 0 ~ Port 3 sSATA Device Type (Available when a SATA port is
detected)
nected to a Solid State drive or a Hard Disk Drive. The options are Hard Disk
Drive and Solid State Drive.
Support Aggressive Link Power Management
When this item is set to Enabled, the SATA AHCI controller manages the power
usage of the SATA link. The controller will put the link to a low power state when
the I/O is inactive for an extended period of time, and the power state will return
to normal when the I/O becomes active. The options are Enabled and Disabled.
Load EFI Driver for RAID
This option enables the system to load the RAID EFI driver during system boot.
Select Enabled to load the EFI driver, select Disabled to load the legacy driver
for system boot.
Serial ATA Port 0~ Port 3
This item displays the information detected on the installed SATA drives on the
particular SATA port.
•
Model number of drive and capacity
Port 0 ~ Port 3 Spin Up Device
On an edge detect from 0 to 1, set this item to allow the PCH to start a COMRE-
SET initialization to the device. The options are Enabled and Disabled.
Port 0 ~ Port 3 SATA Device Type
nected to a Solid State drive or a Hard Disk Drive. The options are Hard Disk
Drive and Solid State Drive.
7-28
PCIe/PCI/PnP
-
NB PCIE Setting
CPU SLOT1 PCI-E 3.0 X8 (IN X16) - Gen X
Auto, Gen1 (2.5 GT/s), Gen2 (5 GT/s) and Gen3 (8 GT/s).
CPU Port2 Bifurcate
This option distributes PCI-E Port2 to SLOT2 and SLOT4, or SLOT4 only. The
options are Slot2 and Slot4 and Slot4.
-
CPU SLOT2 PCI-E 3.0 X8 (IN X16) - Gen X
Auto, Gen1 (2.5 GT/s), Gen2 (5 GT/s) and Gen3 (8 GT/s).
CPU SLOT4 PCI-E 3.0 X8 (IN X16) - Gen X
Auto, Gen1 (2.5 GT/s), Gen2 (5 GT/s) and Gen3 (8 GT/s).
BIOS
7-29