Omron CJ Series Operation Manual page 113

Device variable
Type
(name)
Input Signal Type
*_Ch#_SensTypCfg UINT
Advanced alarm functions
*_Ch#_AlmHystrsValCfg UINT
*_Ch#_AlmOnDelayTmCfg UINT
Process value scaling
*_Ch#_PVSclValCfg_H INT
*_Ch#_PVSclValCfg_L INT
Expansion Operation Data allocation settings *2
*_ExtIOCfg WORD
*_ExtIOAdr UINT
Parameter status
*_CfgErrAdr UINT
*1 The ERC indicator on the Unit's front panel will light if an out-of-range setting is made in either Setting Param-
eter Group 1 (Continuously Refreshed Parameters) or Setting Parameter Group 2 (Initial Settings Parameters).
The offset (the number of words) from the start address to the lowest memory address that has the range error
will be stored in the Address of Data Range Error.
For the correspondence between range error addresses and setting parameter addresses, refer to A-3 Corre-
spondence Table of Analog I/O Unit Variables and CJ-series CPU Addresses. "m" in the table indicates the
First Word allocated in DM. m = D20000 + (N × 100) (N: Unit number)
*2 When specifying Expansion Operation Data, be sure that the area does not overlap with other areas that are in
use.
If areas overlap, the memory may be overwritten and unexpected operation may occur.
CJ-series Analog I/O Units Operation Manual for NJ-series CPU Unit(W498)
R/W Data range Default
RW 0 to 54
RW 0 to 9999
RW 0 to 60
−32000 to +32000
RW +4000
−32000 to +32000
RW
RW 16#0000 or 16#0000 Expansion Operation Data Setting
16#0001
RW 0 to 6143
R 0 to 40
3 Isolated-type Universal Input Units
Parameter contents
54 0: RTD-Pt100 21: TC-K
3: RTD-JPt100 23: TC-J
7: RTD-Pt1000 25: TC-T
33: TC-L
36: TC-R
37: TC-S
38: TC-B
0 Alarm Hysteresis
• Temperature input: Set value × 0.1 °C, or 0.1 °F
• Voltage or current input: Set value × 1 digit
0 Alarm ON-delay Time
Unit: s
Scaling Value for Maximum Value in Range (Span)
0 Scaling Value for Minimum Value in Range (Zero)
0: Not used, 1: Used
0 First Word in Expansion Operation Data Area
In the Expansion Operation Data, the same data as
PVAlmSta is output.
0 Address of Data Range Error
48: 4 to 20mA
49: 0 to 20mA
50: 1 to 5V
53: 0 to 5V
54: 0 to 10V
3
3-9