G-Lite PODIUM WAVE 100 User Manual page 21

ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
Unpacking your PODIUM WAVE 100 where will be using it. Being careful
Not to damage . Place your PODIUM WAVE 100 on a level flat surface.
It is recommended that you place a protective covering
on your floor.
STEP 1 . Mount the stand tube onto the main unit,
connect the down- lead from the both parts.
See Figure 1 .
STEP 3: Put washers and bolts into their
correspondent holes and then fix them with
a spanner or wrench.
STEP 2 Attach the main tube to the vibrator
with bolts and washers provide.
STEP 4: Screw the handle bar to the stand tube
tightly. Pull out the endcap (21) for the wiring
hole on the rear of the stand tube (17).
21