Connecting The Power Cord - H3C S6812 Series Installation Manual

Connecting the power cord

WARNING!
Provide a circuit breaker for each power module and make sure the circuit breaker is off before
installation.
To connect the power cord for a power module:
1. Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2. Attach the power cord retainer clip (supplied with the power module) into the two holes next to
the AC-input power receptacle on the power module, and pull the retainer clip leftwards (see
Figure2-49).
3. Connect one end of the AC power cord supplied with the power module to the power receptacle
(see callout 1 in Figure2-50).
4. Pull the retainer clip rightwards to secure the connector to the AC-input power receptacle (see
callout 2 in Figure2-50).
5. Connect the other end of the power cord to an AC power source.
Figure2-49 Connecting a power cord (1)
2-35