Laser Safety; Installation Tools; Installation Accessories - H3C S6812 Series Installation Manual

•
Use electromagnetic shielding, for example, shielded interface cables, when necessary.
•
To prevent signal ports from getting damaged by overvoltage or overcurrent caused by lightning
strikes, route interface cables only indoors.

Laser safety

WARNING!
• The switch is a Class 1M laser device.
• Disconnected optical fibers or transceiver modules might emit invisible laser light. Do not stare
into beams or view directly with optical instruments when the switch is operating.

Installation tools

No installation tools are provided with the switch. Prepare the following tools yourself:
•
ESD wrist strap
•
Flat-blade screwdriver
•
Phillips screwdriver
•
Marker
•
Needle-nose pliers
•
Diagonal pliers

Installation accessories

Before installation, make sure you have all the required installation accessories. If an installation
accessory is damaged or lost, purchase a new one by using the BOM code in Table1-3.
Table1-3 Installation accessories
BOM code
2150A03X
2150A0BP
2150A050
2150A0CP
Description
Front mounting kit, including a pair of
front mounting brackets and eight M4
screws
Rear mounting bracket kit, including a
pair of rear mounting brackets and two
shoulder screws
1U long slide rail and chassis rail
1U super-short slide rail and chassis rail
4
Applicable
Quantity
device models
1 pair, provided All models
1 pair, optional All models
1 pair, optional All models
1 pair, optional All models