Hotcupboard Installation - AGA R7 100-3 User's Manual & Installation Instructions

17. Hotcupboard installation

NOTE: The AGA R7 hotcupboard should arrive with the top plate in a jacked up position (except for induction top versions
which will arrive with the top fully wound down). This is to allow the complete appliance to be slid onto its plinth when
alongside the AGA R7 without the top plates clashing. The hotcupboard top plate should then be wound down to its correct
height once the appliance is in its final position.
For induction top versions the top plate adjusters will need to be wound upwards before the hotcupboard can be
fitted onto its plinth, in order to provide adequate clearance between the two top plates.
1. Detach hotcupboard from plinth by removing two screws and tongue bracket from plinth (Fig. 17.1), slide hotcupboard
forwards and away from rear fixing bracket (Fig. 17.2).
Fig. 17.1
Fig. 17.2
30
DESN 516448
DESN 516449